Mon premier quadri, le V666.
J'ai voulu tester l'étanchéité et à présent je peux affirmer qu'il n'aime pas l'eau :-(
J'ai voulu tester l'étanchéité et à présent je peux affirmer qu'il n'aime pas l'eau :-(
Le test sur le site RCGROUPS
Initialisation :
Find a very flat even surface....
Turn on the remote
Set all trims to center
Set RC transmitter to power 100%
Plug in red connector. Large white is for FPV camera only. Don't have to plug in now
Place quad on surface let sit 5 seconds
On the remote move throttle stick up and down. ( quad will beep )
Move both sticks to left lower corner and hold ( quad lights blink rapid )
QUAD READY TO OPERATE
Push throttle slow up. Let motors run slowly. ( break in is recommended )
Turn on the remote
Set all trims to center
Set RC transmitter to power 100%
Plug in red connector. Large white is for FPV camera only. Don't have to plug in now
Place quad on surface let sit 5 seconds
On the remote move throttle stick up and down. ( quad will beep )
Move both sticks to left lower corner and hold ( quad lights blink rapid )
QUAD READY TO OPERATE
Push throttle slow up. Let motors run slowly. ( break in is recommended )
Commentaires